Watts Premier 25 Specifications download pdf (Page 12)

Page 12 of 18

ALARMS

M-Series processors are equipped with audible alarms.

1. The Constant Tone signals lack of incoming water pressure.

(-------------------------------------------------------- Constant Tone)

• Check incoming feed pressure to ensure a minimum of 20 psi.

• Water pressure below 20 psi will trigger alarm. Incoming feed water

pressure must be raised.

2. One second intermittent beeping signals systems is in Auto –Bypass.

(-- -- -- -- -- -- -- -- -- -- -- -- -- -- One second intermittent tone).

• During initial start up with empty tank, the system will automatically be in

Auto-Bypass until the tank has completely filled. The Auto by pass will only be

triggered if the tank pressure drops below 5 psi (Pressure tank systems). Float

switch controlled Atmospheric tank systems with float switches, remain on until

tank is full and processor has turned off automatically.

3. Two second intermittent beeping indicates possible wiring problem or

problem with installation of Float Switches.

(---- ---- ---- ---- ---- ---- Two second intermittent tone.)

Solution:

• Check to ensure labeled

electrical cables are connected

to corresponding float

switches.

• Check conductivity of wire to

ensure no broken wire cables

exist.

• Verify Float position per

drawing to the right.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Watts Premier 25 Specifications Page 12