Watts Premier WP5-50 Troubleshooting Guide download pdf (Page 10)

Page 10

Thread the plastic elbow (supplied in the parts bag) onto the stainless

steel connection on the top of tank. Tighten using an adjustable

wrench. Do not over tighten as plastic could crack.

Step 17

Step 18

Wrap (7 to 12 turns) of Teon tape clockwise around the male pipe

threads (MPT) on the Stainless Steel tting on top of the tank.

Tank Elbow Installation

Do not let the tape cover the opening.

Note:

Connect Blue Tube from “TANK” Port on RO Module to the Tank

Position tank in desired location. Stand it upright or lay it on its side (using the black plastic

stand). Measure the blue tube from the RO module port marked “TANK” over to the tank

and cut it to desired length.

Insert the blue 3/8” tube into the compression side of the elbow previously installed on top of

the storage tank and push in as far as it will go. Tighten the compression nut securely with a

wrench.

Step 19

Step 20

Step 21

Connect the Red Tube from Faucet to RO Module

Insert the open end of the red 1/4” tube attached to the RO faucet

into the 1/4” X 1/4” quick connect tting on the RO Manifold. Make

sure the tube is pushed in all the way to the tube stop. (See Picture)

Connect red faucet tube.

Green Tube Connection

Step 16

Locate green tube attached to the RO Module. Insert the open

end of the green 1/4” tube into the open 1/4” quick connect tting

on the plastic water feed valve making sure the tube is pushed in

all the way to the tube stop.

Green Tube

Adapt-a-Valve

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

No comments

Watts Premier WP5-50 Troubleshooting Guide Page 10