Watts Premier WP5-50 Troubleshooting Guide download pdf (Page 8)

Page 8

Turn off the cold water supply to the faucet by turning the angle stop valve completely off.

Open cold water sink faucet to relieve pressure.

Step 7

Step 8

Choosing the conguration that ts your plumbing, attach the adapt-a-valve as illustrated in

the four photos above.

Adapt-a-Valve Installation

Do not use Teon tape with the Adapt-a-Valve.WARNING:

Caution:

Water supply line to the system must be from the cold water supply line only.

Hot water will severely damage your system.

3/8” Conguration

(With Brass Fittings)

* Insert White Washer

1/2” Conguration

(Without Brass

Fittings)

*White

Washer

Hot

Supply

Cold

Supply

Hot

Supply

Cold

Supply

Verify contents prior to installation:

( 1 ) - Plastic Adapt-a-Valve with black collet

( 1 ) - Brass Adapter no washer

( 1 ) - Brass Adapter with black washer

( 1 ) - White rubber washer

Make sure that the black collet is installed in to the 1/4” opening on the Adapt-a-valve.

Don’t forget to install the white compression washer with the 3/8” conguration.

Brass adapter (A) does not need to be tightened with a wrench, only nger tight.

Black

Collet

TIPS:

White

Washer

Reverse Osmosis Module Mounting

Step 9

Do not cut any RO system tubes at this timeNote:

Determine best location for the RO module to be mounted to allow

for future system maintenance. Using the mounting holes on the

bracket, mark the location for the mounting screws on the cabinet

wall under the sink. In the parts bag, locate the two self tapping

screws. Using an electric drill with a Phillips bit, screw them into

the cabinet at the marked location. Hang the module on the screws

using the mounting holes in the bracket

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comments to this Manuals

No comments

Watts Premier WP5-50 Troubleshooting Guide Page 8

Comments to this Manuals

Related products and manuals for Water dispensers Watts Premier WP5-50